Zanussi Electrolux Gas hobs Manual de Serviço descarregar pdf (Página 12)

1. INSTALLATION PLACE

• The appliance must only be installed in adequately

ventilated premises.

1.1. APPLICABLE STANDARDS

 Install the appliance in compliance with the safety standards

currently in force in the country of use.

2. POSITIONING

• The appliance may be installed separately, side by side with

other appliances from our range, or mounted on tables.

• This appliance is not suitable for built-in installation.

• The appliance must be positioned at least 10 cm away from the

side and rear walls.

• Thermal insulation must be fitted if the appliance is positioned

less than 10 cm from the wall, or installed either directly on the

floor or on flammable material.

• Carefully remove the protective film from the external panels to

avoid leaving any trace of glue.

Use a suitable diluent to remove any glue residue.

• Close the holes on the side of the appliance by means of the

plugs supplied.

2.1 JOINING APPLIANCES (fig. 2)

• Position the appliances together provisionally; level to the

correct height and separate.

• Attach the adhesive tape "C" on the edges of the tops to be

joined.

• Apply a bead "D" of special sealant (ref. code 059611) on the

upper edge of the side.

• Join the appliances and fix by means of holes "A" and "B" using

M5x20 screws and secure by means of nuts and washers.

• Remove excess sealant by means of a spatula and remove the

adhesive tape.

Warning!

The sealant begins polymerization starting from the external

surface: it is recommended not to touch the sealant in the first

three hours after application in order to avoid any trimming.

3. GAS CONNECTION

3.1. WARNINGS

• Before installing the appliance, contact the local gas supply

authority.

• Refer to the technical data and figures shown at the beginning

of this instructions manual for the space requirements and

connection dimensions of the appliance.

• Before connecting the appliance to the gas line, remove the

plastic cover from the gas connection on the appliance.

• Make sure that the appliance corresponds with the gas supply

to which it is connected. If this is not the case, follow the

instructions shown in the paragraph " Conversion to different

types of gas".

• Install the pressure regulator the appliance is supplied with

ahead of the appliance.

• Figure 3 shows how to install the pressure regulator:

- "1-3" gas connection towards the appliance;

- "1-2" pressure regulator;

- "1-4" gas connection towards the gas supply.

• The section of the gas supply pipe must be such as to assure

enough gas capacity to be able to operate all appliances

connected to the gas line.

• The arrow on the pressure regulator indicates the direction of the

gas flow. It is convenient to install the pressure regulator horizontally

to assure the right outlet pressure.

• This models have been projected and certified to be used with

natural gas or propane. When natural gas is to be used the

pressure regulator on the collector will be set to 8" w.c. (20mbar).

• Once the appliance has been installed, check for gas leaks at

connection points using a soapy water solution.

• Installation and maintenance (of gas, electric current etc.) must

only be carried out by the local power supply authority or an

authorized installer.

3.2. GAS EXHAUST FOR TYPE "A1" APPLIANCES

It is a good idea to install "A1" type appliances under an extractor

hood to ensure the removal of gases and steam generated

during cooking.

II. INSTRUCTIONS FOR INSTALLATION

1 2 ... 7 8 9 10 11 12 13 14 15 16 17

Comentários a estes Manuais

Sem comentários

Zanussi Electrolux Gas hobs Manual de Serviço Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Zanussi Electrolux Gas hobs