Zanussi-Electrolux ZGF68XE Manual do Utilizador descarregar pdf (Página 11)

FO 0199

Fitting the Hob into the worktop

Carry out the building in of the hob as follows:

• place the seals supplied with the hob on the side

edges of the cut out and at 8 mm from the front and

rear edges, as shown in the diagram, taking care

that the seals meet without overlapping;

• place the hob in the cut out, taking care that it is

centred;

• fix the hob with the relevant fixing clamps and screws,

as shown in the diagram. When the screws have been

tightened, the excess seal can be removed.

The edge of the hob forms a double seal which prevents

the ingress of liquids.

Building over a kitchen unit with

door

Proper arrangements must be taken in designing the

furniture unit, in order to avoid any contact with the bottom

of the hob which can be heated when it is operated. The

recommended solution is shown in diagram 3.

The panel fitted under the hob ("a") should be easily

removable to allow easy access if technical assistance

is needed. The space behind the kitchen unit ("b") can

be used for connections.

Seal

Rectangular cut-out size for hob

Cut Out Size

The dimensions of the cut-out are given in the diagram.

FO 2038

100

Dimensions are given in mm.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Sem comentários

Zanussi-Electrolux ZGF68XE Manual do Utilizador Página 11