Zanussi-Electrolux ZGF68XE Manual do Utilizador descarregar pdf (Página 8)

A) End of shaft with nut

B) Washer

C) Elbow

FO 0814

Gas Connection

Connection to the gas supply should be with either rigid

or semi-rigid pipe, i.e. steel or copper.

The connection should be suitable for connecting to RC

1/2 (1/2 BSP male thread).

When the final connection has been made, it is essential

that a thorough leak test is carried out on the hob and

installation.

Ensure that the main connection pipe does not exert

any strain on the hob.

It is important to install the elbow correctly, with

the shoulder on the end of the thread, fitted to the

hob connecting pipe.

Failure to ensure the correct assembly will cause

leakage of gas.

Installation

IMPORTANT: This hob must be installed by a

competent person to the relevant Gas Standards.

Please, ensure that, once the hob is installed, it

is easily accessible for the engineer in the event

of a breakdown.

WHEN THE HOB IS FIRST INSTALLED

Once the hob has been installed, it is important to

remove any protective materials, which were put

on in the factory.

Any gas installation must be carried out by a

competent person.

The manufacturer will not accept liability, should

the above instructions or any of the other safety

instructions incorporated in this book be ignored.

On the end of the shaft, which includes the GJ 1/2"

threaded elbow, adjustment is fixed so that the washer

is fitted between the components as shown in the

diagram. Screw the parts together without using

excessive force.

FO 0264

Important safety requirements

ICLEARANCES REQUIRED

WHEN FITTING THE HOB

WITHOUT A COOKER HOOD ABOVE

CLEARANCES REQUIRED

WHEN FITTING THE HOB

WITH A COOKER HOOD ABOVE

FO 0813

FO 0812

700 mm

Location

The hob may be located in a kitchen, a kitchen/diner or

bed sitting room, but not in a bathroom, shower room or

garage.

Before making the cut out in the worktop ensure that

there is a minimum distance of 55 mm between the rear

edge of the hob and the wall.

A minimum distance of 100 mm must be left between

the side edges of the hob and any adjacent cabinets or

walls.

The minimum distance combustible material can be fitted

above the hob in line with the edges of the hob is 400

mm. If it is fitted below 400 mm a space of 50 mm must

be allowed from the edges of the hob.

The minimum distance combustible material can be fitted

directly above the hob is 700 mm.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comentários a estes Manuais

Sem comentários

Zanussi-Electrolux ZGF68XE Manual do Utilizador Página 8

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Zanussi-Electrolux ZGF68XE